Size guide
What do you do most?
A good place to start
Solid outline: suggested for that work. Maker guidance, as a starting point. Control and hand fit decide.
Check the pair you own
- Overall length is roughly the inch size. Use a real ruler on the pair you own. Tip to ring end: 15.2 cm is 6.0″. Makers differ on whether the finger rest counts.
- Blade length, pivot to tip, is the reach you cut with. Product pages show blade length when the maker publishes it.
Happy with what you use now? Stay with that size. Half an inch shorter gives more control at the tip. Longer gives more reach.
Quick fit check
- Palm: rest the shear flat on your palm. Tip near your middle finger: that length is worth trying.
- Rings: they should hold without squeezing. Your thumb should slide out freely. Inserts tighten a loose ring.
A shear size is a number in inches, and makers do not all arrive at it the same way. One counts the finger rest, another stops at the ring, and the figure on the label may be a rounded nominal size. Nominal size, overall length and blade length are three separate numbers, so a 6.0 from one maker can sit differently in your hand than a 6.0 from another.
Use this page to narrow things down, not to pick a single size. Start from the work: short, detailed cuts usually point to 5.0 to 5.5 inches, a mixed book to 5.5 to 6.0, and long sections or barbering to 6.5 to 7.0. Then lay the pair you own on a real ruler and measure it the way its maker does. Before you add anything to your cart, confirm which lengths that model comes in and in which hand. Hand size is one clue among several, so hold a couple of lengths if you can.






